eNBioAccess-T5 Fingerprint Access Controller

Product Details

How To Configure Network Settings From Device

a] Click administrator menu in initial screen

b] Now it moves to Main Menu Screen, Click “Network” icon in sub menus.

C] Click “NORMAL” Button.

d] Select “wireline” button.Data encryption mode can be selected as DES or AES_256 mode.If any option value is changed, please click left bottom “Save” button to maintain current values. If there is no changed, click “Back” button to go to below menu.

e] Click “TCP/IP” button.

f] Click “Terminal ID” button.

g] Input terminal ID from 1 to 2000. Do not input the same ID with other terminal.(Left Figure)

h] Input IP address of PC used as Access Manger server and click “OK” button.(Right Figure)

i] Above shows the display after setting. To save configuration, click “Save” button. (When setting “DHCP” off)

j] Connect LAN cable to network connector in the back of the terminal.Network status shows unregistered terminal.Register terminal in “AccessManager Pro”.

C] Click “USER” butoon. 

d] To add new user, click “+” button.

e] Registration scrren is displayed. The first user will be registered with master privilege Select “ID” input window.

f] ID keypad is displayed.

g] After inputting ID, click “OK” button. The default ID length is 4.

h] In “AUTH TYPE1” select “Finger”.

i] Select the finger you wish to register.

j] The terminal requires fingerprint twice. Place your finger on the scanner after voice instruction.

k] The terminal displays fingerprint image. After capturing first image, please remove the finger and replace the same finger.

l] The above displays screen when fingerprint is successfully captured twice.

m] Click ‘Save” button. (10 fingerprints can be saved for each ID.)

n] If fingerprint is registered successfully, “Finger” button is changed with blue mark.Click ‘Save” button to finish registration. The above image shows the registration of ID “1234” with only fingerprint.

o]  It shows that ID “1234” is added.

a] After inputting ID, click “OK” button. The default ID length is 4.

b] In “AUTH TYPE1” select “Password”.

 c] Keypad for password is displayed. 

d] After inputting password, click “OK” button. To confirm password, please input password again.

e] If password is registered, “Password” button is changed with blue mark. Click ‘Save” button to finish registration. The above image shows the registration of ID “0001” with only password.

f] shows that ID “0001” is added.

a] Click administrator menu in initial screen 

b] Click “User” icon in sub menus

c] Click “USER” button.

d] Select user to be deleted. In example, ID”0001” is selected

d] Click “Wastebasket” icon to delete.  

f] The above warning message is displayed. To continue, click “Yes” button.

g] It shows that ID “0001” is deleted.